Excitation Application Form

 
 
Fields Mark as * are Mandatory
Site Details :
Company* :  
 
Industry* :   Other :  
 
Contact Person* :   Address1* :  
   
Designation :   Address2 :  
Email* :   City* :  
   
Telephone* :   State* :  
   
Fax :   Pin/Zip Code* :  
 
Country :  
Plant* :  
 
1. Machine Data :
Kilowatts* :   kW Manufacturer* :  
   
Rated Voltage* :   V Type / No.* :  
   
Rated Current* :   A Speed* :   RPM
   
Frequency* :   Hz   p.f.  Type of Prime Mover* :  
          
2. Exciter Type :
Main Exciter Pilot Excitor (Applicable for AC Brushless Exciters)


Rated Output* :   kW
 

Rated Output* :   kW
 
Rated Voltage* :   V Rated Current* :   A
   
No Load Voltage* :   V
 
Frequency*:   Hz
 
* With AC exciter or permanent Magnet Generator only
3. Excitation Data of Synchronous Machine :
3A. Main Field Data
No Load Excitation Voltage* :  V
 
No Load Excitation Currentt* :  A
 
Excitation Voltage at Full Load Rated P.F.* :  V
 
Excitation Current at Full Load Rated P.F.* :  A
 
Excitation Current at Continuous Short Circuit of* :  %     Rated Current*    A
                 
Rotor Resistance* :  / W at ºC
 
Main Field Time Constant T do* : sec.
 
3B. Exciter Field Data
No Load field Voltage* :  V
 
No Load field Current* :  A
 
Field Voltage at Full Load Rated P.F.* :  V
 
Field Current at Full Load Rated P.F.* :  A
 
Excitation Current at Continuous Short Circuit of* :  %     Rated Current*    A
             
Field Resistance* :  / W at ºC
 
Exciter Field Time Constant* : sec.
 
** With short circuit support (Compounding) only.
4. Operating Data :
Measuring Transformers for Voltage Regulation
Voltage Transformer
Primary :   V Secondary :   V Burden :  
     
Connection of Voltage Transformers
Current Transformer
Specify Ratio :    /   Burden :  
       
5. For protection of Alternator & Accessories requirement :
Automatic change over from Auto / Manual mode :
Power factor regulator :
Minimum / Maximum exciter limiter :
Voltage Buildup scheme (Field flashing) :
Exciter diode monitor unit : 
Generator Protection Scheme requirement :
Local / Remote Operation detail :
Redundancy required at power or control stage :
Field flashing is "Yes", please provide following details :
1. Schemate of existing Excitation Circuitry (this is optional, but if you have then please part with us)
Note : The Schemate can be sent by e-mail or through some other media later on. You will be notified by e-mail to send the schemate once your request is received by us.
2. Residual voltage of alternator   Volt
 
3. No load exciter field requirements   Volt   Amp
   
4. DC bus Voltage for field flashing ( specify voltage of auxiliary source to be used for field flashing)   Volt
 
Remarks :